Search results

... can easily hear everyone else, without raising their voice. (transmission power) They get best (momentary) gain from the system by simply turning their radio power up all the way, and ignoring any traffic by stamping on it.

* Power: 2 × AA battery or via AC adapter

Powered off the Neo, powered on with AUX+POWER go give a reduced boot menu.

* Поддержка кнопок AUX и POWER для навигации в меню

====Shutting down: "themfish power down" ====

#Power up the bluetooth radio

* Power button press ...t 30mA additional standby current, since we cannot properly switch off the power supply to the S3C2410 PLL's. There is nothing we can do to change this wit

* To prevent interference with the GSM modem you have to expicitly power-up and register the modem by toggeling the "GSM State" checkboxes.

* ''Automatically power-on the gsm chip and register to a network on launch''

...нужного пункта необходимо нажать кнопку POWER. neo1973 power-off - switch off the phone

|Cámara de dos megapixes, cuatro botones (power, volume up, volume down, mute, Home), [http://es.wikipedia.org/wiki/Aceler%

...ct an option you have to press enter (=aux) and to execute it, hit space (=power). The default selection will boot Openmoko.

...functions which fall outside the scope of [[gsmd]] such as the buttons and power management. It is considered a temporary, throw-away solution [http://svnwe * [[Power management menu]]

# Push the power button of your Neo1973 to swithc it on

...he logical mode of the USB port, the Neo FreeRunner can provide 5 volt USB power to an attached USB device. To enable this (not available on Neo 1973): Note that in full USB host mode the FreeRunner will power the external device. To avoid draining the battery use a powered USB hub, t

Here are some non-specific requirements for Openmoko regarding power management of the phone. There are three general classes of requirements: # The phone should save power as much as possible to keep run times as long as possible.

Now you must power up the GPS-chip by opening the "Settings" application and setting the GPS e

...]] || Fonctionne || (Aka PMU) Fakes the battery charge level (set at 88%), POWER button, etc. Also contains an RTC, also unused by Linux. |Boutons || Fonctionne || Enter is the AUX button, Space is the POWER button. Wired to on-chip GPIO and PCF50606.

Located behind the POWER button at the bottom-right of the device. Located behind the POWER button.

# Remove the USB cable and the Battery for a moment to remove all power from the Neo, or ...lect "Shutdown device" (Note: "Restart Device" does not help - you need to power it down completely!)