I2C Humidity Sensor
From Openmoko
(Difference between revisions)
m (→Mounting) |
|||
| Line 16: | Line 16: | ||
I tried the first two options. After drilling small holes both places can be used, but even without top cover I was able to measure a temperature difference of about one degree celsius between the inside and outside of the case. | I tried the first two options. After drilling small holes both places can be used, but even without top cover I was able to measure a temperature difference of about one degree celsius between the inside and outside of the case. | ||
| + | |||
| + | [[Category:Accessories]] | ||
Latest revision as of 17:49, 9 September 2010
[edit] General description
The SHT21 from Sensirion is a digital humidity and temperature sensor with a easy to use I2C interface. It connects to your Freerunner just like the I2C Pressure Sensor.
A simple kernel driver is already available from here.
[edit] Mounting
The relative humidity depends on the ambient temperature. This makes it rather difficult to find the best mounting place for the sensor. The requirements are:
- contact with fresh air
- minimize errors introduced through heat from other electronic components.
[edit] Possible mounting places
- next to the GPS antenna
- inside the GSM antenna
- behind the speaker holes
- ...
I tried the first two options. After drilling small holes both places can be used, but even without top cover I was able to measure a temperature difference of about one degree celsius between the inside and outside of the case.
