View source for Disassembling Neo1973/it
From Openmoko
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page:
Templates used on this page:
Return to Disassembling Neo1973/it.
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page:
Templates used on this page:
Return to Disassembling Neo1973/it.
NOTE: La pagina Disassemblare il Neo1973 mostra come aprire la revisione hardware GTA01Bv3. Future revisioni potrebbero richiedere aggiornamenti a questa pagina. |
Per rimuovere il frontalino posteriore, inserite l'unghia nel piccolo incavo in cima al Neo, e tirate leggermente.
NOTE: Adesso dovete rimuovere le due viti Torx (T6x40) |
Per rimuovere il frontalino anteriore, dopo aver rimosso le due viti Torx, inserire prestando attenzione la parte finale del plettro per chitarra fornito in dotazione tra il frontalino stesso ed il case nella parte inferiore del dispositivo, e far scivolare il plettro da un lato verso la parte superiore (non piegare il plettro). Mentre fate scorrere il plettro, le clip di attacco al case dovrebbero sganciarsi emettendo un click. Ripetere la procedura per l'altro lato del dispositivo. Per sganciare l'ultima grossa clip in cima, far scivolare il plettro sino a raggiungere la parte superiore (questa operazione potrebbe risultare complicata) e poi premere dal centro. Facendo forza prestando attenzione la clip si sgancera' permettendo la completa rimozione del frontalino.
In questa immagine e' possibile vedere, dalla destra, andando in senso orario.
Al centro c'e' l'LCD touchscreen; la piattina di controllo del touchscreen si vede in basso a sinistra dell'LCD, attraverso il vetro.
NOTE: The Disassembling the Neo1973 page shows how to open up the GTA01Bv3 hardware revision. Future hardware revisions may require updates to this page. |
To remove the back cover, put your fingernail at the small recession on top of Neo, and pull a bit.
NOTE: You now need to remove the two Torx screws (T6x40) |
To remove the top cover, after removing the two torx screws, carefully squeeze the end of the supplied guitar pick between the cover and the case at the bottom of the device, and then slide the pick up to the top on one side (do not twist the pick). As you slide the pick along, the case retaining clips should come apart with a snapping sound. Repeat the procedure for the other side of the device. To unclip the last remaining large retaining clip at the top, slide the pick all the way to the top (this can be difficult) and then press it in at the centre. By careful application of force the clip will detach and the cover can then be removed.
Visible in this image, from the right, going clockwise.
In the middle is the touchscreen LCD, the touchscreen printed wire can be seen beginning at the bottom left of this, through the glass.
{{note|Dovete piegare il case allargandolo leggermente sino a quando il jack della cuffia sul lato sinistro del dispositivo non si sganciage:Gta01b v3 case top open pcb lift white.jpg|700px]]